SIEMENS
7/234
Siemens D 21.4 · 2017
SINAMICS S120 drive system
Chassis format
Motor-side power components for chassis format
> Sine-wave filters
7
■
Overview
If a sine-wave filter is connected to the output of the Power Module
or Motor Module, the voltage between the motor terminals is
virtually sinusoidal. This reduces the voltage load on the motor
windings and prevents motor noise induced by the pulse
frequency.
The pulse frequency of the modules must be set to 4 kHz for the
sine-wave filters. The max. output frequency with sine-wave filter
is limited to 150 Hz.
As a result, the max. possible output current and the max.
achievable output voltage of the units are reduced. The voltage
drops across the sine-wave filter, a factor which must also be
taken into account in the drive design.
A sine-wave filter must be installed as close as possible to the
Motor Module or Power Module.
It is only permissible to operate the sine-wave filter when the
motor is connected (sine-wave filters are not no-load proof)!
For additional information on sine-wave filters, please refer to the
SINAMICS Low Voltage Configuration Manual.
■
Selection and ordering data
Suitable for Power Module
Suitable for Motor Module
Type rating
at 400 V, 50 Hz
(460 V, 60 Hz)
Rated
output
current
Sine-wave filter
Air-cooled
Liquid-cooled
Air-cooled
Liquid-cooled
kW (hp)
A
Article No.
Line voltage 380 ... 480 V 3 AC
6SL3310-1TE32-1AA3
6SL3315-1TE32-1AA3
6SL3320-1TE32-1AA3
6SL3325-1TE32-1AA3
110 (150)
210
6SL3000-2CE32-3AA0
6SL3310-1TE32-6AA3
6SL3315-1TE32-6AA3
6SL3320-1TE32-6AA3
6SL3325-1TE32-6AA3
132 (200)
260
6SL3310-1TE33-1AA3
6SL3315-1TE33-1AA3
6SL3320-1TE33-1AA3
6SL3325-1TE33-1AA3
160 (250)
310
6SL3000-2CE32-8AA0
6SL3310-1TE33-8AA3
–
6SL3320-1TE33-8AA3
–
200 (300)
380
6SL3000-2CE33-3AA0
6SL3310-1TE35-0AA3
6SL3315-1TE35-0AA3
6SL3320-1TE35-0AA3
6SL3325-1TE35-0AA3
250 (400)
490
6SL3000-2CE34-1AA0
© Siemens AG 2017