SIEMENS
4/5
Siemens D 31 · 2015
4
SINAMICS G120C compact inverters
0.55 kW to 18.5 kW (0.75 hp to 25 hp)
SINAMICS G120C compact inverters
■
Configuration
The following electronic configuring guides and engineering
tools are available for SINAMICS G120C compact inverters:
Drive Technology Configurator (DT Configurator) within
the CA 01
The interactive catalog CA 01 – the offline Industry mall of
Siemens on DVD-ROM – contains over 100,000 products with
approximately 5 million possible drive system product variants.
The Drive Technology Configurator (DT Configurator) has been
developed to facilitate selection of the correct motor and/or
inverter from the wide spectrum of drives. It is integrated as a
selection tool in Catalog CA 01.
Online DT Configurator
In addition, the DT Configurator can now be used on the Internet
without requiring any installation. The DT Configurator can be
found in the Siemens Industry Mall at the following address:
/dt-configurator
SIZER for Siemens Drives engineering tool
The SIZER for Siemens Drives engineering tool makes it easy to
engineer the SINAMICS and MICROMASTER 4 drive families.
It provides support when selecting the hardware and firmware
components necessary to implement a drive task. SIZER for
Siemens Drives covers the full range of operations required to
configure a complete drive system.
You can find further information on SIZER for Siemens Drives in
the section Engineering Tools.
The SIZER for Siemens Drives engineering tool is available free
of charge on the internet at
/sizer
STARTER commissioning tool
The STARTER commissioning tool allows menu-prompted
commissioning, optimization and diagnostics. Apart from the
SINAMICS drives, STARTER is also suitable for
MICROMASTER 4 devices.
You can find further information on the STARTER commissioning
tool in the section Engineering Tools.
Additional information on the STARTER commissioning tool is
available on the internet at
/starter
SINAMICS Startdrive commissioning tool
SINAMICS Startdrive is a tool for configuring, commissioning,
and diagnosing the SINAMICS family of drives and is integrated
into the TIA Portal. SINAMICS Startdrive can be used to imple-
ment drive tasks with the SINAMICS G120, SINAMICS G120C,
SINAMICS G110M (SINAMICS Startdrive V13 and higher),
SINAMICS G120D and SINAMICS G120P (SINAMICS Startdrive
V13 and higher) inverter series. The commissioning tool has
been optimized with regard to user friendliness and consistent
use of the TIA Portal benefits of a common working environment
for PLC, HMI and drives.
You can find further information on the SINAMICS Startdrive
commissioning tool in the section Engineering Tools.
The SINAMICS Startdrive commissioning tool is available free of
charge on the internet at
/startdrive
Drive ES engineering system
Drive ES is the engineering system that can be used to integrate
the communication, configuration and data management func-
tions of Siemens drive technology into the SIMATIC automation
world easily, efficiently and cost-effectively. The STEP 7 Man-
ager user interface provides the ideal basis for this. A variety of
software packages are available for SINAMICS –
Drive ES Basic, Drive ES SIMATIC and Drive ES PCS.
You can find further information on the Drive ES engineering
system in the section Engineering Tools.
Additional information on the DRIVE ES engineering system is
available on the internet at
/drive-es
© Siemens AG 2014