SIEMENS
Reference notes
1.
After the inspection, contact Little Rock Plant for
authorization of repair or replacement. Unapproved
repairs will be denied.
2.
Removal, reinstallation, freight and service calls are
NOT covered by warranty.
3.
A standard EASE Warranty report must be filled out and
a Siemens job/p.o. # issued. The Warranty report and
nameplate (if motor scrapped in the field) plus the
invoice must be sent to the Little Rock Plant.
4.
Premium efficiency motors will modify major repair
pricing by increasing schedule 10%.
5.
Allowances listed are for open drip-proof and totally
enclosed, non-ventilated motors with class B or F
insulation and all voltages between 100 and 600 volts.
For variations consult factory.
6.
Minor repairs – consist of all the operations listed
under minor repairs plus the cost of material and
rewinding of stator. If no allowance is shown, consult
the factory.
7.
Major repairs-consist of all the operations listed under
major repairs plus the cost of material and rewinding
of stator.
If no allowance is shown, consult the factory.
8.
Shaded areas represent units that will be replaced
when possible, without repairs.
9.
Replacement Parts – will be furnished at no Charge
from the factory, i.e. bearings for 40 HP and above.
10. Replacement Motors – will be furnished at no Charge
from the factory. Should it be necessary for reasons of
expediency for the service shop to replace a motor
from their stock, a replacement motor will be furnished
at no Charge from the factory, shipped Freight allowed.
11. Defective parts, i.e. bearings, are subject to return
upon request to the factory for inspection and approval
for reimbursement.
Date coding
Siemens SIMOTICS motors are date coded by the model
number/date code/serial number on the nameplate.
Siemens date codes for NEMA frame size, low voltage
motors built in USA and Mexico is as follows:
The first digit is alphabetic and represents the month. The
second and third digits are numeric and are the last two
digits of the year.
A = January
G = July
B = February
H = August
C = March
J = September
D = April
K = October
E = May
L = November
F = June
M = December
IMPORTANT NOTICE
MAIL INVOICE PLUS PROPER WARRANTY REPAIR REPORT
TO THE WARRANTY ADMINISTRATOR. IF SIEMENS IS TO
BE BILLED FOR OVERTIME, AUTHORIZATION MUST BE
OBTAINED FROM WARRANTY ADMINISTRATOR BEFORE
OVERTIME WORK IS PERFORMED. MATERIAL AND SERVICES
ARE PURCHASED FOR RESALE AND ARE EXEMPT FROM
STATE AND LOCAL SALES AND USE TAX.
Introduction
Warranty and support
1-4
2015 Low Voltage AC Motors Selection and Pricing Guide